Table of Contents
Advertisement
2.2.2
Connecting the Ground pin
Step 1. System ready and find the Equipotential Terminal on rear side of POC.
An Equipotential Terminal provides an option to connect to a hospital ground/earth
system.
Step 2. Prepare the grounding cable and the other terminal links to the hospital
ground/earth system.
Step 3. Grounding cable plug with POC-S199 series Equipotential Terminal
2.3
Running the BIOS Setup Program
Your POC-S199 series was probably set up and configured by your dealer prior to
delivery. You may still find it necessary to use the BIOS (Basic Input-Output System)
setup program to change system configuration information, such as the current date
and time or your type of hard drive. The setup program is stored in read-only mem-
ory, it can be accessed either when you turn on or reset the panel PC, by pressing
the "F2 or Del" key on your keyboard immediately after powering on the computer.
The settings you specify with the setup program are recorded in a special area of
memory called CMOS RAM. This memory is backed up by a battery so that it will not
be erased when you turn off or reset the system. Whenever you turn on the power,
the system reads the settings stored in CMOS RAM and compares them to the
equipment check conducted during the power on self-test (POST). If an error occurs,
an error message will be displayed on screen, and you will be prompted to run the
setup program.
2.4
Installing System Software
Recent releases of operating systems from major vendors include setup programs
which load automatically and guide you through hard disk preparation and operating
system installation. The guidelines below will help you determine the steps necessary
to install your operating system on the panel PC hard drive.
Note!
Some distributors and system integrators may have already pre-
installed system software prior to shipment of your panel PC.
POC-S199 Series User Manual
Figure 2.5 Grounding cable with connector
12
Advertisement
Table of Contents
