Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Advantech POC-S175
Summary of Contents for Advantech POC-S175
-
Page 1: User Manual
POC-S175 Slim Point of Care Terminal with 17" TFT LCD monitor User Manual... - Page 2 No part of this man- ual may be reproduced, copied, translated or transmitted in any form or by any means without the prior written permission of Advantech Co., Ltd. Information provided in this manual is intended to be accurate and reli- able.
- Page 3 Product Warranty (1 years) Advantech warrants to you, the original purchaser, that each of its prod- ucts will be free from defects in materials and workmanship for two years from the date of purchase. This warranty does not apply to any products which have been repaired or...
- Page 4 1.1 FCC Class B This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a residential environment.
-
Page 5: Packing List
1.2 Packing List Before installing your Point of Care Terminal, ensure that the following materials have been received: • POC-S175 series Point of Care Terminal • User's manual • Accessories for POC-S175 • Y-shaped adapter for PS/2 mouse and keyboard •... -
Page 6: Safety Instructions
6. Put this equipment on a reliable surface during installation. Dropping it or letting it fall may cause damage. 7. The openings on the enclosure are for air convection. Protect the equipment from overheating. DO NOT COVER THE OPENINGS. POC-S175 User Manual... - Page 7 8. Make sure the voltage of the power source is correct before connecting the equipment to the power outlet. 9. Position the power cord so that people cannot step on it. Do not place anything over the power cord. 10. All cautions and warnings on the equipment should be noted. 11.
- Page 8 IEC 60601-1-1. Everybody who connects addi- tional equipment to the signal input part or signal output part configures a medical system, and is therefore, responsible that the system complies with the requirements of the system standard IEC 60601-1-1. The unit is POC-S175 User Manual viii...
- Page 9 27. The sound pressure level at the operator's position according to IEC 704-1:1982 is no more than 70dB(A). DISCLAIMER This set of instructions is given according to IEC 704-1. Advantech disclaims all responsibility for the accuracy of any statements contained herein...
- Page 10 POC-S175 User Manual...
-
Page 11: Table Of Contents
Environment ..............4 1.2.9 Cleaning/Disinfecting ............ 5 LCD Specifications ............5 Dimensions................ 6 Figure 1.1:Dimensions of the POC-S175 ...... 6 Chapter 2 System Setup............ 8 A Quick Tour of the POC-S175........8 Figure 2.1:Front view of Point of Care Terminal ..8 Figure 2.2:Rear view of Point of Care Terminal ... - Page 12 Figure 6.1:Win2000 Driver Installation ....... 32 6.2.2 Installation for Windows XP ........33 Figure 6.2:WinXP Driver Installation ......33 Further information ............34 Appendix A VESA Mounting ..........36 Install VESA Mounting ..........36 Figure A.1:VESA mounting 75x75mm, 100x100 mm 37 POC-S175 User Manual...
- Page 13 General Information This section provides general informa- tion and technical specifications about the POC-S175 Sections include: • Introduction • Specifications • LCD Specifications • Dimentions...
-
Page 14: Chapter 1 General Information
PC-based system with 17" color TFT LCD display, on-board PCI Ether- net controller, dual COM port interfaces and a 16-bit stereo audio control- ler. With a built-in 2.5” HDD drive, and CF card sockets, the POC-S175 is as slim and user-friendly as a notebook computer and low audible noise. -
Page 15: Flat Panel Interface
• Memory: 1 x 200 pin SO-DIMM sockets, support ECC Double Dat- aRate (DDR)128 MB to 512 MB, accept 128/256/512 MB DDR200/ 266DRAM (855GME could support to DDR333 DRAM) • System chipset: Intel 855GME or 852GM GMCH/ ICH4 Chipset 400 MHz PSB •... -
Page 16: Touchscreen (Optional)
1.2.6 Touchscreen (Optional) Table 1.1: Type Analog Resistive Resolution Continuous Light Transmission Controller RS-232 interface (uses COM4) Power Consumption +5V@200 mA Software Driver Supports Windows 2000,Windows XP Durability (touches in a lifetime) 30 million Table 1.2: Table 1.1:Touhscreen specification Note The Point of Care Terminal with the optionally installed touchscreen will share COM4. -
Page 17: Cleaning/Disinfecting
Agents: Green tinctured soap and Enzy- matic detergents Steps: 1. Wipe the POC-S175 with a clean cloth that has been moistened in the cleaning solution. 2. Prepare agent per manufacturer’s instructions or hospital protocol. 3. Wipe thoroughly with a clean cloth... -
Page 18: Dimensions
• LCD MTBF: 50,000 hours • Backlight lifetime: 50,000 hours (typical) 1.4 Dimensions Figure 1.1: Dimensions of the POC-S175 POC-S175User Manual... - Page 19 System Setup This section gives a quick tour of the POC-S175 including installation proce- dures, BIOS Setup, and software and driver installation...
-
Page 20: Chapter 2 System Setup
Chapter 2 System Setup 2.1 A Quick Tour of the POC-S175 Before you start to set up the POC-S175, take a moment to become famil- iar with the locations and purposes of the controls, drives, connections and ports, which are illustrated in the figures below. -
Page 21: Figure 2.2:Rear View Of Point Of Care Terminal
When you turn the Point of Care Terminal around and look at its rear cover, the sunken I/O section is at the bottom of the panel PC, as shown in Figure 2-2. (The I/O section includes various I/O ports, including serial ports, VGA port, the Ethernet port, USB ports, the microphone jack, and so on.) Figure 2.2: Rear view of Point of Care Terminal... -
Page 22: Installation Procedures
2.2 Installation Procedures 2.2.1 Connecting the power cord The POC-S175 could only be powered by a DC power adapter (XPiQ Model no.PCM80PS24). Be sure to always handle the power cords by holding the plug ends only. Follow these procedures in order: 1. -
Page 23: Connecting The Keyboard And Mouse
2.2.2 Connecting the keyboard and mouse 1. Connect the Y-shaped adapter to the PS/2 mouse and keyboard port on the I/O section of the POC-S175. (See Figure 2-4.) 2. Connect the PS/2 mouse and keyboard to the Y-shaped adapter. (See Figure 2-4.) -
Page 24: Running The Bios Setup Program
2.3 Running the BIOS Setup Program Your POC-S175 is likely to have been properly set up and configured by your dealer prior to delivery. You may still find it necessary to use the BIOS (Basic Input-Output System) setup program to change system con- figuration information, such as the current date and time or your type of hard drive. -
Page 25: Installing The Drivers
CD-ROM is: Figure 2.6: File dir "Drivers and Utilities" of CD Note The drivers and utilities used for the POC-S175 panel PCs are subject to change without notice. If in doubt, check Advantech's website or contact our application engineers for the latest information regarding drivers and utilities. - Page 26 POC-S175 User Manual...
- Page 27 PCI Bus Ethernet Inter- face This section includs information about the high-performance Ethernet network chipset...
-
Page 28: Chapter 3 Pci Bus Ethernet Interface
Chapter 3 PCI BUS Ethernet Interface 3.1 Introduction The POC-S175 is equipped with a high-performance 32-bit Ethernet chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD standards. It is supported by major network operating systems. It is also both 100Base-T and 10Base-T compatible. -
Page 29: Figure 3.1:Lan Driver Installation
Figure 3.1: Lan Driver Installation Chapter 3... -
Page 30: Further Information
3.3 Further information For further information about the Ethernet installation in your POC- S175, included Driver updates, troubleshooting guides and FAQ lists please visit the following web resources. Realtek website: www.intel.com.tw Advantech websites: www.advantech.com www.advantech.com.tw POC-S175 User Manual... - Page 31 PCI Graphic Setup This section describes the PCI Graphics card setup and driver installation.
-
Page 32: Chapter 4 Pci Graphic Setup
Chapter 4 PCI Graphic Setup 4.1 Introduction The POC-S175 has an onboard PCI/AGP flat panel interface. The specifi- cations and features are described as follows: 4.1.1 Chipset The POC-S175 uses a Intel 855GME/852GM for its graphic controller. It supports LVDS LCD displays, and CRT monitors. - Page 33 Note2 <Enter> means pressing the “Enter” key on the keyboard. Note3 Before you install the graphic driver of POC-S175, please ensure you have installed the INF driver of the Intel 855GME/852GM chipset. You can find this driver in the Utility CD-ROM.
-
Page 34: Installation For Windows 2000/Xp
4.2.1 Installation for Windows 2000/XP Figure 4.1: Graphic Driver Installation POC-S175User Manual... -
Page 35: Further Information
4.3 Further information For further information about the AGP/SVGA installation in your POC- S175, included Driver updates, troubleshooting guides and FAQ lists please visit the following web resources. Intel website: www.intel.com.tw Advantech websites: www.advantech.com www.advantech.com.tw Chapter 4... - Page 36 POC-S175User Manual...
- Page 37 Audio Interface This section explains the audio inter- face of the POC-S175 and installation of the Windows 2000/XP drivers...
-
Page 38: Chapter 5 Audio Interface
Before installing the audio driver, please take note of the procedures detailed below. You must know which operating system you are using in your POC-S175, and then refer to the corresponding installation flow chart. Just follow the steps in the flow chart. You can quickly and successfully complete the installation, even though you are not familiar with instructions for Windows. -
Page 39: Figure 5.1:Audio Driver Installation
5.2.1 Installation for Windows 2000/XP Figure 5.1: Audio Driver Installation Chapter 5... -
Page 40: Further Information
5.3 Further information For further information about the Audio interface installation in your POC-S175, included Driver updates, troubleshooting guides and FAQ lists please visit the following web resources. Realtek website: www.realtek.com.tw Advantech websites: www.advantech.com www.advantech.com.tw POC-S175 User Manual... - Page 41 Touchscreen Interface This section explains the Touchscreen Interface including its specifications, operating conditions, and driver instal- lation for Windows 2000/XP...
-
Page 42: Chapter 6 Touchscreen Interface
Chapter 6 Touchscreen Interface 6.1 Introduction 6.1.1 General Information The POC-S175's optional touchscreen incorporates advanced second- generation 5-wire resistive technology. They allow 75% light transmission respectively. The resistive and capacitive models have an antiglare surface. All models provide greatly enhanced visual resolution. -
Page 43: Installation Of Driver For Touchscreen
• Turpentine • Mineral spirits • Foods and beverages 6.2 Installation of Driver for Touchscreen To facilitate installation of the touchscreen driver, you should read the instructions in this section carefully before you attempt installation. Important The following windows illustrations are examples only. You must follow the flow chart instructions and pay attention to the instructions which appear on your screen. -
Page 44: Installation For Windows 2000
6.2.1 Installation for Windows 2000 Figure 6.1: Win2000 Driver Installation POC-S175 User Manual... -
Page 45: Installation For Windows Xp
6.2.2 Installation for Windows XP Figure 6.2: WinXP Driver Installation Chapter 6... -
Page 46: Further Information
6.3 Further information For further information about the Touchscreen installation in your POC- S175, included Driver updates, troubleshooting guides and FAQ lists please visit the following web resources. Elo website: www.elotouch.com Advantech websites: www.advantech.com www.advantech.com.tw POC-S175 User Manual... -
Page 47: Vesa Mounting
VESA Mounting The following section explains how to install the VESA mounting system for the POC-S175... -
Page 48: Appendix A Vesa Mounting
1. The wall-mounting attachment is comprised of two parts: one back bracket, and one mounting bracket. 2. First attach the back bracket to the rear cover of the POC-S175, secur- ing it in place with four of the philips-head screws provided. -
Page 49: Figure A.1:Vesa Mounting 75X75Mm, 100X100 Mm
Figure A.1: VESA mounting 75x75mm, 100x100mm Appendix A... - Page 50 POC-S175 User’s Manual...