2.2
Installation Procedures
2.2.1
Connecting the Power Cord
The POC-W152/W152C can only be powered by a DC power adapter (Sinpro Model
HPU101-107). Be sure to always handle the power cords by holding the plug ends
only.
Follow these procedures in order:
1.
Connect the female end of the power adapter to the DC jack of the panel PC.
(See Figure 2.5)
2.
Connect the female end of the power cord to the DC power adapter.
3.
Connect the 3-pin male plug of the power cord to an electrical outlet.
2.2.2
Connecting the Ground Pin
1.
System ready and find the Equipotential Terminal on rear side of POC. An Equi-
potential Terminal is provide to optionally connect to a hospital ground/earth
system
Figure 2.6 POC-W152/W152C Equipotential Terminal Pin
2.
Prepare the Grounding cable and the other terminal link to hospital ground/earth
system.
3.
Grounding cable plug with POC-W152/W152C Equipotential Terminal (See Fig-
ure 2-7).
POC-W152/W152C User Manual
Figure 2.5 Connecting the power cord
Figure 2.7 Grounding cable with connector
10
Equipotential Terminal