Installation Procedures; Connecting The Power Cord; Connecting The Ground Pin - Advantech POC-WP21 Series User Manual

2.2

Installation Procedures

2.2.1

Connecting the Power Cord

The POC-WP21 series can only be powered by AC in. Be sure to always handle the
power cords by holding the plug ends only.
Follow these procedures in order:
1. Connect the female end of the power cord to the system.
2. Connect the 3-pin male plug of the power cord to an electrical outlet.
2.2.2

Connecting the Ground Pin

1. System ready and find the Equipotential Terminal on rear side of POC.
An Equipotential Terminal is provide to optionally connect to a hospital ground/
earth system
Figure 2.5 POC-WP21 Series Equipotential Terminal Pin
POC-WP21 Series User Manual
Figure 2.4 Connecting the Power Cord
10