Table Of Parameters - Siemens SINUMERIK 840D Description Of Functions

02.99
4.15

Table of parameters

Default setting
Value range
(minimum and
maximum value)
Effectiveness of
changes
Protection level
Unit
Index
 Siemens AG 2000. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital Descr. of Functions HLA Module (FBHLA) – 04.00 Edition
The machine data is preset to this value during start-up.
Specifies the input limits. If no value range is indicated, the data byte deter-
mines the input limits and the field is marked with "∗∗∗".
S
POWER ON (po) "RESET" key on front panel of the NCU module
or disconnection and reconnection of power supply
of softkey "NCK Reset"
S
NEW_CONF (cf) – Softkey "Set MD active" on MMC
– "RESET" key on control unit,
– Changes can be made in program mode at block
S
RESET at end of program M2/M30
S
RESET (re) "RESET" key on control unit or
S
Immediately (im) after entry of the value
The levels of effectiveness have been listed above in order of priority.
Protection levels 0 to 7 have been used. The lock for protection levels 0 to 3 (4
to 7) can be cancelled by entering the correct password (setting correct key-
switch position). The operator has access to the information on the level to
which he has authorization and to all lower levels.
Meanings of numbers
0 or 10: SIEMENS
1 or 11: OEM-HIGH
2 or 12: OEM-LOW
3 or 13: End user
4 or 14: Keyswitch position 3
5 or 15: Keyswitch position 2
6 or 16: Keyswitch position 1
7 or 17: Keyswitch position 0
The unit is referred to the default setting of machine data
SCALING_FACTOR_USER_DEF_MASK and
SCALING_FACTOR_USER_DEF.
If the MD is not based on any physical unit, then the field is labelled with "–".
Selectable data sets associated with one parameter.
4 Firmware Drive Functions
limits
4.15 Table of parameters
4-163