Parameters Table - Siemens Sinumerik 840D Series Function Manual

02.99
10.03
Processor capacity
utilization
5735 PROCESSOR_UTILIZATION
Processor capacity utilization
Unit: Default:
% 0
4.15

Parameters table

Default value
Range of values
(minimum and
maximum)
Changes take
effect
Protection level
 Siemens AG, 2003. All rights reserved
SINUMERIK 840D/SIMODRIVE 611 digital, HLA Module (FBHLA) - 10.03 Edition
Minimum: Maximum:
0 FFFF
The processor capacity utilization display provides online information about
available computing capacity.
The machine data is preset to this value during start-up.
Specifies the input limits. If no range of values is specified, the data type deter-
mines the input limits and the field is marked "∗∗∗".
S
POWER ON (po) "RESET" key on front panel of NCU module
or disconnection and reconnection of power supply
or "NCK reset" soft key
S
NEW_CONF (cf) - "Set MD active" soft key on HMI
- "RESET" key on control unit,
- Changes at block ends possible in program mode
S
RESET at end of program M2/M30
S
RESET (re) "RESET" key on control unit or
S
Immediately (im) after entry of the value
The levels of effectiveness have been listed above in order of priority.
Protection levels 0 to 7 have been used. The lock for protection levels 0 to 3
(4 to 7) can be canceled by entering the correct password (correct keyswitch
position). The operator only has access to information protected by one particu-
lar level and the levels below it.
Meanings of numbers
0 or 10: SIEMENS
1 or 11: OEM-HIGH
2 or 12: OEM-LOW
3 or 13: End user
4 or 14: Keyswitch position 3
5 or 15: Keyswitch position 2
6 or 16: Keyswitch position 1
7 or 17: Keyswitch position 0
4 Firmware Drive Functions
4.15 Parameters table
Cross reference: -
Related to: Protection level:
HLA 3/3
Data type:
Active:
UNS. WORD
Read-only
4-165