Preparation Of The Triple Function Handpiece Kavo One - KaVo ESTETICA E30 Care Instructions

Care instructions ESTETICA E30
2 Reprocessing methods according to DIN EN ISO 17664 | 2.4 Preparation of the dentist element
2.4.4 Preparation of the triple function handpiece KaVo
One
Note
Wet the O-rings of the gripping sleeves after sterilisation using silicone
grease (Mat. no. 1.000.6403) or KaVo Rota Spray 2 (Mat. no.
0.411.7510). After replacing the cannula, the air channel must be blown out
before the start of treatment to ensure that the air exiting during treatment
is dry.
Note
For the cleaning/preparation of the cannula of the triple-function handpiece
KaVo One, the cannula must be disassembled into the cannula tube and the
taper sleeve.
Cleaning of triple-function handpiece KaVo One
Automatic cleaning
Damage caused by improper cleaning/disinfection.
▶ Do not sterilise the single parts of the cannula in a hot-air steriliser.
▶ Do not place the single parts of the cannula in a disinfectant or ultrasonic
bath.
▶ Single parts of the cannula should be subjected to thermodisinfection and
sterilisation.
Manual cleaning
Note
Combine manual cleaning with disinfection.
Internal cleaning
▶ Leave the cannula and handpiece on the instrument, and activate the air
and water for 60 seconds.
External cleaning
Accessories required:
o
▪ Tap water 30 C ± 5
▪ Brush, e.g. medium-hard toothbrush
▶ Hold the valve body of the handpiece and screw off the cannula.
▶ Disassemble the cannula of the triple-function handpiece KaVo One into the
cannula tube and the taper sleeve.
▶ Clean the cannula tube and taper sleeve by brushing them under flowing
water (at least tap water quality).
▶ Immediately remove contamination from materials used in the dental prac-
tice (impression materials, caustic chemicals).
▶ Carefully wipe off contamination from the cannula tip with a soft Q-tip or
soft cloth and alcohol.
NOTICE
o
C
12 / 40