Smart Slot - Delta Ultron DPM Series User Manual

SMART
Slot

SMART SLOT

BYPASS BREAKER OUTPUT BREAKER
NO NC COM NO NC
NO NC COM NO NC
MANUAL BYPASS BREAKER INPUT BREAKER
(Figure 4-2: Communication Interfaces_ on the Front of the UPS System Cabinet with Two Front Doors Open)
4.1.1 SMART Slot
You can install one of the following optional cards in the SMART slot. For each card's
function, please refer to the table below.
Optional Card
SNMP Card*
Relay I/O Card
MODBUS Card
NOTE:
1. If you need any optional card, please contact your local dealer or customer
service.
2. *
the rear of the touch panel (please see Figure 4-31). If the touch panel's IC is
damaged, which causes that you cannot use the network port, you can purchase
the optional SNMP card and install it into the SMART slot to let the UPS have
SNMP function. For more information about the network port, please refer to
Page 4-21 and Page 4-22.
RS-232 USB Parallel
Ports Ports Ports
RS-232
PM
SYS
PM
SYS
BATTERY BREAKER EXTERNAL BATT. TEMP. DETECTION
COM NO COM G1
B1
COM NC COM B2 G2
BATTERY FUSE
1
1
The UPS has a network port, which has SNMP function and is located at
External
Breaker
Parallel Detection Display
Switch Dry Contacts Port
PARALLEL
EXTERNAL BREAKER DETECTION
PARALLEL
DISPLAY
SWITCH
OUTPUT DRY CONTACT
B3
G3 OD1 OD1 OD3
B4 G4 OD2 OD2 OD4
Helps you remotely monitor the status of the UPS
via internet.
Increases the quantity of dry contacts.
Lets the UPS have MODBUS communication.
4-3
4 Communication Interfaces
External Battery Output/
Temperature Input
Detection Dry Dry
Contacts Contacts
EXTERNAL BATT. OUTPUT/INPUT
TEMPERATURE DETECTION DRY CONTACT REPO
EPO Port
INPUT DRY CONTACT
G1
OD3 OD5 OD5 ID1
OD4 OD6 OD6 ID2 G2
Function
Battery
REPO Start
Port Button
BATT. START
REPO
NC
COM NO COM
NC COM NO COM
EPO