2: Displays And Leds - Honeywell NOTIFIER UDACT Instruction Manual

Normal Mode
Mode
Pressing the
the four modes of operation.
NOTE: To enter Normal Mode from any other mode press
6676 spells NORM on a Touch-Tone
1st Event
This key along with the Up Arrow and Down Arrow keys, are used to display UDACT fault
conditions. Press the 1
Down Arrow
Use the Down Arrow key to view other fault events (older) that have occurred and are active - not
cleared yet.
Up Arrow
Use the Up Arrow key to view other fault events (newer), that have occurred and are active - not
cleared yet.
Enter/Store
See individual mode descriptions in other sections for detailed descriptions of the
key.
4.1.2 Displays and LEDs
Four, seven-segment red LED characters (see below) provide visual annunciation of UDACT
trouble conditions. A list of messages that may appear on the display in Normal Mode is shown
below:
UDACT Instruction Manual — P/N 50050:M 12/18/2009
key followed by a valid 4-digit numerical code and
MODE
® phone.
key at any time to display the first event that occurred.
ST EVENT
Message Meaning
PH_1 Primary Number Communication Fault
PH_2 Secondary Number Communication Fault
no_1 Primary Phone Line Fault
no_2 Secondary Phone Line Fault
Table 4.1 Normal Mode Messages
Operating Instructions
/ selects one of
ENTER STORE
, then 6676, then
MODE ENTER
ENTER
/
.
STORE
/
STORE
49