Status Displays - Honeywell CDMA-X Installation And Setup Manual

Intellipath series cdma communicator
Table of Contents

Advertisement

Status Displays

Service
[E]
RSSI
1X/EVDO
REG
-xxxdbm
stat
x
RAN
Ec/I0 (dBm)
1X
-xxx
SID
NID
xxxx
xxxxx
Cell
Channel
N/A
xxx
CDMA-X Installation and Setup Guide
Status Display Screen 1
RSSI – RSSI level in dBm.
Communicator is on 1X/EVDO network where "stat" can be:
Good
RSSI –20 to –90 dBm
OK
RSSI –91 to –100 dBm
Marginal RSSI –101 to –106 dBm
Bad
RSSI –107 to –150 dBm
REG – Registration status where "x" can be:
N – Not Registered
H – Registered Home
S – Searching
D – Registration Denied
R – Registered Roaming
? – Unknown Registration State
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the last screen.
Status Display Screen 2
RAN – Radio Access Network. (1X or IS-95A)
Ec/I0 – Ratio of channel power to traffic power; roughly equivalent to noise ratio. A
number closer to zero is better.
Very Good
0
-1
-2
-3
-4
-5
Poor
-11
-12
-13
-14
-15
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 3
SID – System Identification, identifies the cell network in the local area.
NID – Network Identification, identifies the overall network.
Press the [space] key to get to the next screen.
Press the [backspace] key to go to the previous field.
Status Display Screen 4
Cell – Base Station ID
Channel – Control Channel in use.
Press the [space] key to go to the next screen.
Press the [backspace] key to go to the previous field.
Good
Fair
-6
-7
-8
-9
-10
-11
High Noise
-16
-17
-17
-19
-20
– 18 –

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents