System Status Displays
Test Msg Sent
Reset CPU Y/N
Force Server Update?
Strt Prog Mode?
Displays system fault status.
Flt: Represents radio faults
OK: Normal, No fault
I: No network connectivity over IP and fault time has
i: No network connectivity over IP and fault time has
G: No network connectivity over Cell and fault time has
g: No network connectivity over Cell and fault time has
NOT yet expired.
NOTE: The 7720P will not operate if the power line voltage is
Sends a Test alarm to AlarmNet. Functional for a registered
communicator only. If the device is not registered, a message
is displayed indicating that the command cannot be executed.
Pressing [N] returns to diagnostic mode (blank screen = enter
next command or escape).
Pressing [Y] resets the communicator (blank screen = reset
Registers a programmed communicator with AlarmNet.
with PIN for Replacement Communicator
Registers a replacement communicator with AlarmNet, once
programmed, using the existing PIN #.
Force Upload of Configuration File to Server
Pressing [Y] will force the device to upload its entire configura-
tion file to the server.
Pressing [N] cancels the operation.
NOTE: If the internet is not available, and the communicator is
not initialized when you enter this command, the following
screen will be displayed:
Try Later! _
Wait for the
nicator has completed its initialization, and try again.
Enter Program Mode
Press [Y] to enter program mode; otherwise, press [N].
LEDs to light, indicating the commu-