Installing/Uninstalling/Modifying The Sinumerik Integrate Server; Overview - Siemens SINUMERIK 840D Installation Manual

Installing/uninstalling/modifying the SINUMERIK
Integrate server
4.1

Overview

When installing the server, you also install interfaces between the application and the machine
clients.
Additional Windows services which are started automatically as background services each
time the server is started are required for this server variant.
Prerequisites
The following conditions must be fulfilled:
● The license server must be available and configured.
Additional information is provided in chapter: Set license server (Page 73).
● The additional Windows services are set and the SQL Server is installed.
Additional information is provided in chapter: Installing/configuring Windows services
(Page 25).
● You will require administrator rights (current Windows or SQL user) to perform the
installation.
● If you are operating and installing a virtual machine on a PC running the "Windows 10"
operating system, then turn off "Airplane mode".
Optimize MyProgramming /NX-Cam Editor
● The NX CAM server is installed and ready for operation.
If you have any further questions, please contact NX CAM Support at: NX /CAM support
(https://www.plm.automation.siemens.com/global/de/support/).
Manage MyResources /Tools
● .NET Framework 4.7 is installed and activated.
Additional information is provided in chapter: Setting up Internet Information Services
and .NET Framework (Page 26).
Procedure
Perform the following steps:
1. Set the port for the license server.
2. Launch the server setup.
3. Select the installation language.
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE
4
71