Sinumerik Controller Is Onboarded - Siemens SINUMERIK 840D Installation Manual

Connecting applications with the SINUMERIK control system

8.3 SINUMERIK controller is ONBOARDED

8.3 SINUMERIK controller is ONBOARDED
In this chapter you will be shown were to see if a Machine is "ONBOARDED" in the Sinumerik
Integrate 5.
You have to make the same steps with all applications:
● Manage MyResources /Programms
● Manage MyResources /Tools
● Optimize MyProgramming /NX-Cam Editor
Procedure
1. Again open the "Plant management" window.
2. The machine is displayed with the connection status "ONBOARDED" in the overview.
178
Manage MyResources, Optimize MyProgramming /NX-Cam Editor
Installation Manual, 12/2019, A5E44672080B AE