Problem Solving Guide - Miele SmartLine CS 7611 Operating And Installation Instructions

Problem solving guide

With the help of the following guide, minor faults in the performance of the
appliance, some of which may result from incorrect operation, can be remedied
without contacting Miele. This will save you time and money because you won't
need a service call.
Please note that a call-out charge will be applied to unnecessary service visits
where the problem could have been rectified as described in these operating
instructions.
Problem
The SmartLine
appliance cannot be
switched on.
A smell and vapours are
given off when the new
wok is being used.
The power level
selected is flashing.
40
Possible cause and remedy
There is no power to the SmartLine appliance.
 Check if the circuit breaker has tripped. Contact
an electrician or Miele (for the minimum fuse
rating, see data plate).
There may be a technical fault.
 Disconnect the SmartLine appliance from the
mains electricity supply for approx. 1 minute by
– switching off at the wall socket and withdrawing
the plug, or
– switching off the main circuit breaker or residual
current device.
 If, after resetting the fuse in the mains fuse box or
the residual current protection device, the
SmartLine appliance will still not switch on,
contact a qualified electrician or Miele.
The metal components have a protective coating.
When the wok is used for the first time, this causes a
smell and possibly also vapour. The material of the
induction coils also emits odours in the first hours of
operation. This smell will be less noticeable with each
subsequent use before dissipating completely. The
smell and any vapours given off do not indicate a
faulty connection or appliance and they are not
hazardous to health.
The wok pan is not in position.
 Place the wok pan in position.