Problem Solving Guide - Miele CS 7611 Operating And Installation Instructions

Problem solving guide

Many malfunctions and faults that can occur in daily operation can be easily
remedied. Time and money will be saved because a service call will not be
needed.
The following guide may help you to find the reason for a malfunction or a fault,
and to correct it.
Problem
The SmartLine element
cannot be switched on.
A smell and vapours are
given off when the new
wok is being used.
The power level selec-
ted is flashing.
After the SmartLine ele-
ment has been
switched on or a sensor
control has been
touched,  appears in
the timer display for a
few seconds.
40
Cause and remedy
There is no power to the SmartLine element.
 Check whether the mains fuse has tripped. Con-
tact an electrician or Miele Service (for the min-
imum fuse rating, see data plate).
There may be a technical fault.
 Disconnect the appliance from the mains electri-
city supply for approx. 1 minute by
– tripping the relevant mains fuse or screwing the
fuse out completely, or
– switching off the residual current protection
device.
 If, after resetting the trip switch in the mains fuse
box or the residual current protection device, the
appliance will still not turn on, contact a qualified
electrician or Miele Service.
The metal components have a protective coating.
When the appliance is used for the first time, this
causes a smell and possibly also vapour. The material
from which the induction coils are made also gives off
a smell in the first few hours of operation. This smell
will be less noticeable with each subsequent use be-
fore dissipating completely. The smell and any vapour
given off do not indicate a faulty connection or appli-
ance and they are not hazardous to health.
The wok pan is not in position.
 Place the wok pan in position.
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
"System lock / Safety lock").