Miele SmartLine CS 7611 Operating And Installation Instructions page 41

Problem
After the SmartLine
appliance has been
switched on or a sensor
control has been
touched,  appears in
the timer display for a
few seconds.
The SmartLine
appliance has switched
off automatically. When
the appliance is
switched back on, 
appears above the On/
Off  sensor control.
After the SmartLine
appliance has been
switched on,  appears
briefly in the timer
display. The SmartLine
appliance does not heat
up.
The wok has switched
itself off automatically.
The Booster has
automatically switched
off early.
A cooking zone is not
working in the usual
way on the power level
selected.
An operating noise can
be heard after the
SmartLine appliance
has been switched off.
Possible cause and remedy
The system lock or safety lock is activated.
 Deactivate the system lock or safety lock (see
"Safety features - System lock / Safety lock").
One or more of the sensor controls are covered, e.g.
by finger contact, food boiling over, or an object.
 Clean off any dirt and/or remove the object (see
"Safety features – Safety switch-off").
The SmartLine appliance is in demonstration mode.
 Touch the 0 and 2 sensor controls at the same
time until  flashes alternately with  in the
timer display.
It has been operated for too long.
 Switch the wok back on (see "Safety features –
Safety switch off").
The overheating protection mechanism has been
activated.
 See "Safety features - Overheating protection".
The overheating protection mechanism has been
activated.
 See "Safety features - Overheating protection".
The overheating protection mechanism has been
activated.
 See "Safety features - Overheating protection".
The cooling fan runs until the SmartLine appliance
has cooled down and then switches off
automatically.
Problem solving guide
41