Status Message - Icom IC-F9020 Series Operating Manual

3
APCO P25 MODE OPERATION
n Status Message
D Transmitting
The transcever can send one of up to 100 dfferent pre-pro-
grammed Status Messages.
[Digital Button] or [Digital Status] key assgnment s neces-
sary to transmt the Status Message.
Not avalable on Non-dsplay types.
✔ For Trunking mode operation:
The Status Message can be sent only to a dspatcher n the
Trunkng mode.
q Push [Digital Button] to enter the dgtal call type selec-
ton mode.
✔ Quick access
Push [Digital Status] to drectly enter the Status Mes-
sage selecton mode. In ths case, skp steps w and e.
Go to step r.
w Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select "STATUS."
For Handheld types:
STATUS
DSEL PAGE
29
For Mobile types:
S T A T U S
STAT
e Push [Digital Button] agan to enter the Status Message
selecton mode.
• A pre-programmed Status Message s dsplayed.
For Handheld types:
STATUS
TX Status 01
DSEL PAGE STAT
r Push [CH Up] or [CH Down], or rotate [CH Up/Down] to
select the desred Message.
Whle n the Trunkng mode, the followng steps t and y
are not necessary. Go to step u.
t Push [Digital Button] (or [Digital Status]) agan to enter
the Indvdual ID selecton mode.
• A pre-programmed ID name s dsplayed.
• When the ID name s not programmed, the ID code s ds-
played.
For Handheld types:
STATUS
INDIVIDUAL1
DSEL PAGE STAT
For Mobile types:
S T A T U S
T X S t a t u s 0 1
For Mobile types:
S T A T U S
I N D I V I D U A L 1