Icom IC-F9020 Series Operating Manual page 50

4
TACTICAL GROUP FUNCTION
D Clonng the tactcal group
<Master (Zone 128) ➔ Sub (Zone 128)> (Contnued)
w Turn the sub transcever power ON.
e Set the master transcever nto the set mode as follows;
For Handheld types:
Whle pushng [ Ω ] and [ ≈ ] on the master transcever, ro-
tate [VOL] to turn the power ON.
For Mobile types:
Whle pushng [P0] and [P4] on the master transcever,
push [ ] to turn the power ON.
• "DEALER" s dsplayed.
47
r Input the 6 dgt dealer passcode, as specfied by your
dealer.
• The 10-keypad* can be used for passcode nput.
* 10-key types only
• When usng a Smple type transcever, the keys n the table
shown below can be used for passcode nput.
• The transcever detects numbers n the same block as dentcal.
Therefore 0 and 5, 1 and 6, etc. are the same.
For Handheld types:
KEY [ Ω ] [I]
0 1
NUMBER
5 6
For Mobile types:
KEY [P0] [P1]
0 1
NUMBER
5 6
NOTE: When the "DEALER" ndcaton does not clear after
nputtng 6 dgts, the nput code number may be wrong.
In that case, turn the power OFF, and start over.
NOTE: A default passcode s "159357";
Push [I], [ Ω ], [ ≈ ], [III], [ Ω ], [II] (Handhelds) or [P1], [P0],
[P4], [P3], [P0], [P2] (Mobles) n sequence.
[II] [III] [ ≈ ]
2 3 4
7 8 9
[P2] [P3] [P4]
2 3 4
7 8 9