D Transmitting A Status Message - Icom iF7010 Series Operating Manual

7
APCO P25 MODE OPERATION
Transmitting a call (Continued)

D Transmitting a Status Message

You can transmit a preset simple message.
A voice signal cannot be sent at the same time.
(Menu > Signaling/Call > Call Menu)
1. Push [Menu] to display the Menu screen.
2. Push [Left] or [Right] to select "Signaling/Call,"
then push [OK].
3. Push [Up] or [Down] to select "Call Menu," then
push [OK].
4. Select "Status," then push [OK].
5. Select a Status Message, then push [OK].
6. Select the target Individual station, then push
[PTT] to transmit the message.
• "Success" is displayed after receiving an
acknowledgment from the target station.
• "Failed" is displayed if the target station does not send
back an acknowledgment.
NOTE: If the following settings are confi gured using
the CS-F7500
programming software
message can be automatically transmitted when the
transceiver is turned ON or OFF.
 Set the Status message to be transmitted in
"Power ON Status" or "Power OFF Status" item,
respectively.
 Set the target station ID in "Power Status ID."
(Digital > Status > Status Setting)
TIP:
• You can also transmit a Status message through
"Status."
(Menu > Signaling/Call > Status)
• Push [Call Menu] to directly display the "Call
Menu" screen in step 4 to the left.
• Push [Status] to directly display the "Status"
screen in step 5 to the left.
• Hold down [Status] for 1 second transmit the
preset Status Message to the currently selected
destination.
7-4
, the Status