Command Timing; Figure 3.4 - Status Reporting Scheme - Newport LDC-3706 Series User Manual

All the IEEE 488.2 Common Commands supported by the LDC-3706 are listed in Table 3.7:
Table 3.7 – IEEE 488.2 Common Commands Supported by LDC-3706
*CLS
*IDN
*RST
*STB?
See Chapter 4 – Command Reference for descriptions of all commands, including common
commands, supported by the LDC-3706. See EVEnt? and CONDition? commands for details for
LASer and TEC condition and event registers.

Command Timing

This section describes, for each device-dependent command, whether that command is performed in
an overlapped or sequential manner. In other words, it states whether the next command may begin
while the first is being executed, or if it must wait until the first command is completed before its
execution begins. See the Operation Complete Definition in chapter 4 for conditions about setting the
operation complete flag.
December 2019
*ESE *ESE?
*OPC *OPC?
*SAV *SRE
*TRG *TST?
Figure 3.4 – Status Reporting Scheme
50
*ESR?
*RCL
*SRE?
*WAI
LDC-3706 Series Laser Controller