Power Supply - Siemens SIMOTION D4 5-2 Series Manual

Supplementary system components
6.5 CX32-2 controller extension
6.5.2.5

Power supply

Application
This interface is provided for the connection of an external power supply.
Note
When using external power supplies (e.g. SITOP), the ground potential must be connected
with the protective ground terminal (PELV).
Characteristics of the interface
Table 6- 25
Characteristics
Connector type
Connection possibility
Max. current carrying capacity incl. loop-through
Max. cable length
Interface assignment
Table 6- 26
Pin
1
2
3
4
Note
The 24 V supply voltage is looped through via the 24 V connector. In this case, pin 1 is
jumpered with pin 2, and pin 3 is jumpered with pin 4 in the connector. The maximum current
can be limited through the current carrying capacity of the cable. The current carrying
capacity of the cable depends, for example, on the type of cable installation (cable duct,
laying on a cable rack, etc.)
Note
The power supply terminal strip must be screwed on tightly using a flat-bladed screwdriver.
122
Interface X124
Power supply X124
Signal name
P24
P24
M
M
Type
Combicon
Up to 2.5 mm
2
20 A
10 m
Meaning
24 V power supply
24 V power supply
Ground
Ground
SIMOTION D4x5-2
Manual, 02/2012