Cabinet B, Inner Door To The Backbox Installation - Honeywell Gamewell-FCI E3 Series Installation & Operation Manual

Installation

2.5.6.5 Cabinet B, Inner Door to the Backbox Installation

1. Place the nylon spacer (5/8" x .314ID x .312) over the backbox, bottom hinge pin as shown in
Location 1 of the figure below.
2. Mount the inner door to the backbox by sliding the inner door top hinge pin hole onto the
backbox top hinge pin as shown in Location 2.
3. Align the inner door bottom hinge pin hole with the backbox bottom hinge pin.
4. Slide the inner door over the inner door bottom hinge pin hole on top of the nylon spacer, and
secure using the #8 x .5" screw as shown in Location 2 of the figure below.
5. After the inner door is secured in place, attach one end of the bonding wire to the top hinge pin
using the #8 x .5" screw as shown in Location 3 of the figure below.
NOTE: For information on the installation of the opposite end of the bonding wire, see Section
2.5.6.6, Step 3 and Location 3 of Figure 2.5.6.6.1.
CABINET B,
INNER DOOR
50
BACKBOX TOP
HINGE PIN
INNER DOOR TOP
HINGE PIN HOLE
SCREW,
#8 x .5"
Figure 2.5.6.5.1 Cabinet B, Inner Door to the Backbox Installation
E3 Series Installation/Operation Manual — P/N 9000-0574:I 11/04/10
CABINET B,
BACKBOX
2
3
3
BONDING
WIRE
2
1
2
BACKBOX
BOTTOM
HINGE PIN
INNER DOOR
BOTTOM
HINGE PIN HOLE
Cabinets