• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
This section describes the procedures for mounting and wiring the control panel and all the peripheral devices.
NOTE: All references in this manual for number of zones, number of user codes, and the event log capacity, use the
VISTA-250FBPT's features. See SECTION 1: General Description for the table listing the differences between the
VISTA-128FBPT and the VISTA-250FBPT control panels.
Mounting the Control Cabinet
To mount the control cabinet, perform the following steps:
Step
Action
1
Before mounting the circuit board, remove the metal knockouts for the wiring entry that you will be using.
DO NOT ATTEMPT TO REMOVE THE KNOCKOUTS AFTER THE CIRCUIT BOARD HAS BEEN
INSTALLED.
2
Using fasteners or anchors (not supplied), mount the control cabinet to a sturdy wall in a clean, dry area
that is not readily accessible to the general public. The back of the cabinet has 4 holes for this purpose.
U L
To provide certificated burglary service for UL installations, refer to the special requirements and Figure 3-2. Cabinet
Attack Resistance Considerations to follow.
Installing the Cabinet Lock
To install the lock, see Figure 3-1 and perform the following steps:
Step
Action
1
Remove cabinet door, then remove the lock knockout from the door. Insert the key into the lock.
2
Position the lock in the hole, making certain that the latch will make contact with the latch bracket when
the door is closed.
3
When correctly positioned, insert supplied lock clip on the inside of the cabinet into the slots on the lock
cylinder. Use an ADEMCO Lock No. N6277V1 and Lock Clip No. P3422-2 (supplied).
Section 3: Installing the Control
Figure 3-1: Installing the Lock
21