I/O Menu Selection; Clock Menu Selection; Misc Menu Selection; Log Menu Selection - Honeywell Gamewell-FCI E3 Series Installation & Operation Manual

I/O Menu Selection

5.3 I/O Menu Selection
Table 5.3.1 lists the I/O Menu selection and description.
Menu Selection
Output ON/OFF
Enable/Disable

5.4 CLOCK Menu Selection

Table 5.4.1 lists the Clock Menu selection and description.
Menu Selection
Time
Date

5.5 MISC Menu Selection

This selection opens a "MISC OPTS" Menu that allows the user to change the RS232 port Baud
rate, or perform a hard reset of the ILI-MB-E3/ILI95-MB-E3/ANX. Baud rate options are provided
to allow connection to a variety of printers. Table 5.5.1 lists the available Baud rates.
Although this change is temporary, it doesn't change the configuration.

5.6 LOG Menu Selection

Table 5.6.1 lists the Log Menu selection and description.
Menu Selection
Display Log
Print Log
Clear Log
Sensitivity Report Will send sensor sensitivity information to the RS-232 port.

5.7 INFO Menu Selection

This selection displays the Firmware Version and time/date of the last configuration change in the
E3 Series
follows:
1. CAMWorks™ Configuration Upload.
2. Auto configuration (Options 1 or 2 on the Autoconfig Menu).
3. Network node map change.
4. Manual update via the "CS" terminal command.
E3 Series Installation/Operation Manual — P/N 9000-0574:I 11/04/10
Description
Forces the toggling on or off of a specified output. These outputs can
include NAC 1, NAC 2, Municipal Circuit (if present) and any
Addressable Control Point.
Allows the user to take any addressable device on either SLC and
disconnect it through software. While disabled, a point will report a
trouble until it is enabled, but will not cause or respond to an alarm.
Table 5.3.1 I/O Menu Selection
Is set in 24 hour notation. It is set with hours, then minutes "HHMM".
Is set as month, date and year "MMDDYY".
Table 5.4.1 Clock Menu Selection
Table 5.5.1 Baud Rates
Opens the System Display to all events in the buffer memory.
Sends the entire buffer memory to the RS-232 port.
(Hard reset) will eliminate all events stored in the buffer memory.
Table 5.6.1 Log Menu Selection
. It shows a code for the type of the most recent configuration update. The codes are as
Description
Baud Rates
Description
Programming
177