System Installation; Installation Requirements Of Cabinet - Honeywell X-618 Installation Manual

3 System Installation

This chapter describes the system equipment installation, cable connections, and relevant
precautions.


Installation Requirements of Cabinet


Installing the Devices in the Appliance Cabinet

Connecting the X-618 System Components

Connecting the Power Supply
Note:

The electricity and power sources must be turned off when performing the following tasks to
avoid electric shocks and damage to the equipment.

Turn off all equipment power supply switches prior to wiring.

Correctly connect the wiring terminals and tighten the screws.

The power supply cables and signal data lines must be separated, and cannot be laid in the
same slot or piping.

For avoiding interfere, speaker lines and power should be separated.

Control signal cables must be positioned away from 100V audio or power supply cables to
avoid signal interference.

Appropriate materials, such as plastic ties, must be used for all connection cables for
reinforcement to avoid looseness. When moving the cables, prevent the power supply cables
from coming in contact with the signal data cables.

Install appropriate electrical cables bushings at the cabinet opening before installing the cables
in the appliance cabinets.

Appropriate materials must be used to block the spaces reserved for the cables at the cabinet
opening if these spaces are not used.
Installation Requirements of Cabinet
Generally, X-618 system needs to be installed in standard 19' cabinet for use. Grounding wire
inside the cabinet should be well connected to keep system work normally. There are specialized
earth wires at the door and the bottom of cabinet. Please refer to following steps:
The cabinet door shaft contains one yellow screw as shown in identified with marker ①. and
marker ②, represents another grounding terminal in the same position in the cabinet. Connect the
two terminals with a wire.
Connect the grounding screw of all devices in the cabinet to the grounding terminal. For safety
reason, it is recommended to connect an external specified grounding terminal to the one on the
cabinet.
7