Electrical Connection - Pepperl+Fuchs PGV -F200 -B6-V15B Series Manual

PGV...-F200/-F200A...-B6-V15B
Installation
5.3

Electrical Connection

The reader is connected electrically via an 8-pin M12 x 1 connector on the side of the housing.
The power is supplied via this connection. The configurable inputs and outputs on the reader
are located at this connection.
1
2
3
4
5
6
7
8
Figure 5.23
Connector Assignment
Main
1
8
7
2
3 5
4
Figure 5.24
Color Assignment
Pepperl+Fuchs single-ended cordsets (female) are manufactured in accordance with
EN60947-5-2. When using a type V19-... (see chapter 4.3) female cordset with an open cable
end on the Main connection, the colors are assigned as follows:
Connection pin
Shielding Cables
The shielding of connection lines is required to suppress electromagnetic interference.
Establishing a low resistance or low impedance connection with the conductor or equipotential
bonding circuit is a particularly important factor in ensuring that these interference currents do
not become a source of interference themselves. Always use connection lines with braided
shield; never use connection lines with a film shield. The shield is integrated at both ends, i.e.,
in the switch cabinet or on the controller and on the read head. The grounding terminal
available as an accessory allows easy integration in the equipotential bonding circuit.
In exceptional cases, the shielding of a connection at one end may be more favorable if
An equipotential bonding cable is not laid or cannot be laid.
32
INPUT_SELECTION_DIR_RIGHT
+ UB
USB_DM
USB_DP
OUTPUT_LANE_PRESENT
INPUT_SELECTION_DIR_LEFT
-UB
IN/OUT 3
6
Strand color
1
2
3
4
5
6
7
8
Color abbreviation
White
Brown
Green
Yellow
Gray
Pink
Blue
Red
WH
BN
GN
YE
GY
PK
BU
RD