Control Software For Windows; Installing The Software; Using The Software - Extron electronics VSC 200 User Manual

im Vertrieb von
COMMAND
Executive Mode
Enable
Disable
Set Output Mode
Set Output Standard
Color Bars
Disable
Enable
Query Software Version Q/q
Request Part Number
Request Information

Control Software for Windows

Installing the Software

Using the Software

www.camboard.de
CAMBOARD Electronics
ASCII RESPONSE DESCRIPTION
X Exe1 Set executive mode to On
x ExeØ Set executive mode to Off
\ Typ Set video output type, (S-video, RGB or component)
X3 X3
# Fnc Set video output standard (NTSC or PAL)
X4 X4
B Blk1 Disable display of NTSC/PAL composite video color
bars when no signal is present
b BlkØ Enable display of NTSC/PAL composite video color
bars when no signal is present
Ver . Example response: Ver1.23
X XX
N/n Nxx-xxx-xx VSC 2ØØ = 6Ø-274-Ø2, VSC 2ØØD = 6Ø-274-Ø1
VSC 3ØØ = 6Ø-275-Ø2, VSC 3ØØD = 6Ø-275-Ø1
I/i Dhz ·Dvt ·Typ
X1 X2
The VSC and DDS Control Program (Extron part number 29-038-01), which is used
by the VSC 200/200D/300/300D, is compatible with Windows® 3.1, 3.11, 95/98,
and NT. It provides remote control of input selection.
The program is contained on a single 3.5" diskette, and it can run from the floppy
drive. However, it is usually more convenient to load and run the program from
the hard drive.
To install the software from the floppy disk onto the hard drive, run SETUP.EXE
from the floppy disk, and follow the instructions that appear on the screen. The
program occupies approximately 1 MB (megabyte) of hard-drive space.
By default, the Windows installation creates a C:\VSC200 directory, and it will
place two icons (VSC + DDS Control Pgm and VSC + DDS Help) into a group or
folder named "Extron Electronics".
1. To run the VSC and DDS Control Program, double-click on the VSC + DDS
Control Pgm icon (left) in the Extron Electronics group or folder.
2. Click on the comm port that is connected to the RS-232 port of
the VSC 200/200D/300/300D.
The Extron VSC and DDS Control Program window appears (see figure 26).
It displays the current settings and the detected input scan rate.
Tel. 07131 911201
VSC 200/200D/300/300D Serial Communication
Fax 07131 911203
·Fnc ·Frz ·Exe ·Hrt
X3 X4 X5 X5 X6
ce-info@camboard.de
·Vrt ·Blk
X6 X5
4-5