Upgrades And Repairs; Internal Access; Installing The Digital Module (D-1) Upgrade Kit; Vsc 200/200D - Extron electronics VSC 200 User Manual

im Vertrieb von
Reference Information
Reference Information, cont'd

Upgrades and Repairs

You can perform the following upgrades and repairs to the scan converter:
• Installing the VSC 200/300 D1 Module (VSC 200/300 only; see below).
• Replacing the AC fuse (see page B-4).
• Installing a firmware update (see page B-5).
Before completing any of these procedures, follow the instructions in "Internal
access", below.

Internal access

Upgrades and fuse replacement require access to the internal areas of the scan
converter. To access the internal areas, do the following:
1.
2.
Figure 27 — Removing the cover
3.
4.
Reverse this procedure to reinstall the cover.

Installing the Digital Module (D-1) upgrade kit

After following the instructions in "Internal access" to remove the cover, do the
following to install the upgrade kit:
1.
2.
www.camboard.de
B-2 VSC 200/200D/300/300D Reference Information
CAMBOARD Electronics
Remove the power cable from the scan converter.
Do not open the cover of the scan converter without unplugging the power cord.
If the scan converter is rack mounted, remove the input and output cables
from it, remove the unit from the rack, and remove the rack mount brackets
(see figure 27). If the scan converter is not rack mounted, you do not need to
remove the input and output cables.
Remove
D1 Connector
Plug
Remove 14 screws from the sides and top of the cover (figure 27).
Remove the cover by slightly lifting each side alternately until the cover is
free.
Remove the jumper on pins 6 and 8 of connector J16 (see exploded view 1 in
figure 28).
Locate the D1 plug directly above the S-video connector on the rear panel (see
figure 27). Remove the plug by pushing it out from the inside.
Tel. 07131 911201
Fax 07131 911203
Remove (14)
Screws
Lift Cover
straight up
Remove #8 Screw
(4 Plcs) Each Side
and Bracket
ce-info@camboard.de