Nice 7251 Installation And Programming Manual page 56

FUNCTION BUTTON / Adv. Settings (Cont.)
From Inputs
(see previous page)
UL Input
Digital NO
(blink)
Motor 1
Master
Remote Mst Slv
Off
Power Fail Open
Off
Motor 12V
Off
Encoder Bemf
Off
Esc
FUNCTION>ADVANCE SETTINGS MENU (Cont.):
• UL INPUT: For analog, select both, open, or close. For digial, select NC (normally closed) or NO (normally
open). NOTE: When set to ANALOG OPEN, CLOSE, or BOTH, input must have an 8.2k-10k Ohm terminated
external entrapment sensor installed. ANALOG BOTH only available for Swing Gates.
• SELECT MASTER / SLAVE: Motor1 or Motor2
• ACTIVATE LINK FOR REMOTE MASTER/SLAVE: Enables control of an additional gate operator board.
• POWER FAIL OPEN: Opens gate automatically on battery backup power if main DC power input loss is
detected.
• MOTOR 12V: Forces motor control voltage to +12VDC even if the supply voltage varies +9.5VDC up to
+35VDC)
• SET VIRTUAL ENCODER: For motors without built-in encoders.
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
56
7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
Analog
Analog
OK
Digital
Motor 2 Motor 1
OK
Slave Slave
Remote Mst Slv
OK
Off
(blinking)
Power Fail Open
OK
Off
Motor 12V
OK
Off
Encoder Bemf
OK
Off
10. Default (see next page)
OK
UL Input
OK
Analog Both
(blinking)
UL Input
OK
Digital NO
(blinking)
Digital
Master/Slave
Motor 2
Master
Slave/Master
OK
On Slave
Off
OK
On
Off
OK
On
Off
OK
On
Off
OK
Both
Open
OK
Close
NO
OK
NC
Remote Mst Slv
OK
On Master
OK
Master
Slave