Nice 7251 Installation And Programming Manual page 54

FUNCTION BUTTON / Charger
6. Events (see previous page)
FUNCTION
7. Charger
8. Standby
(see below)
FUNCTION>CHARGER MENU:
Built-in battery charger is for use with backup battery. Charger may be
manually programmed for customized charge settings or set to "Auto" for
battery charging profile that automatically compensates for temperature
and current during charging. Program the battery charger per the following
parameters.
• CHARGER ON/OFF
• SELECT MAX: current for charging (from 0.1A to 1.5A step 0.05A).
• CYCLING TIME: 1 second off charging every cycling time.
• AUTO: Best charge per temperature.
Charger settings are set by default for most battery charging requirements. If the charger menu is accessed
or modified - ALL settings must be verified by pressing OK or the internal charging system will be turned OFF.
FUNCTION BUTTON / Standby
7. Charger (see above)
FUNCTION
8. Standby
9. Adv. Settings
(see next page)
FUNCTION>STANDBY MENU:
Programs timeout of low power standby mode for gate operator. Settings are from 5 to 120 seconds, or may
be disabled (OFF). During low power standby there is no data displayed on the gate operator LCD and it
consumes a minimum amount of power to extend the life of the backup battery. Most of the outputs, including
output power at #20 (24v) and #38 (12V), are switched off during Standby Mode and the OK LED blinks to
indicate standby status. Output #11 (V+) provides power during Standby Mode.
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
54
7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
Charger
OK
Off
IMPORTANT!
Standby
OK
OFF
On
Off
OK
OFF
NOTE: 30 seconds
120 sec.
is the recommended
setting.
5 sec.
OK
Charger
On
OK
1.5A
Charger
Max I = 1.50A
0.10A
OK
30 Sec.
Charger
Cycling On : 15s
Off/4 Sec.
OK
On
Charger
Auto On : On
Off
OK
On
Charger
Step Up : Off
Off
OK