Nice 7251 Installation And Programming Manual page 45

FORCE BUTTON
FORCE
FORCE
1.Static
Press
FORCE
2.Dynamic
FORCE
3.ESC
SPEED BUTTON
SPEED
SPEED
1. Max
Press
SPEED
2. Standard
SPEED
3. Low
SPEED
4. SlowDown
ACCELERATION
5. Max
ACCELERATION
6. Standard
ACCELERATION
7. ESC
www.ApolloGateOpeners.com | (800) 878-7829 | Sales@ApolloGateOpeners.com
7251 / 7351 Slide Gate Operator
INSTALLATION AND PROGRAMMING MANUAL
10
(min-max
OK
sensitivity)
:5
1
10
(min-max
OK
sensitivity)
:5
0
EXIT
OK
100%
OK
:100
20%
100%
OK
:100
20%
100%
OK
:50
20%
100%
OK
:50
20%
10
(Low
OK
to High)
:10
3
10
OK
:5
1
EXIT
OK
FORCE BUTTON MENU:
Amount of force needed to cause the gate to stop
and reverse when hitting an obstacle.
• STATIC: Set sensitivity to constant force on a
scale of 1 to 10 (1 being the most sensitive).
• DYNAMIC: Set sensitivity of sudden impact
force to the moving gate on a scale of 1 to 10
(1 being most sensitive). 0 = OFF.
• EXIT: Exits the FORCE menu.
SPEED BUTTON MENU:
Sets the speed of the gate under various conditions.
• MAX: Sets limit of max allowed gate speed on scale of 20%
to 100% (20% is lowest setting). It is recommended to set
to default of 100.
• STANDARD: Sets limit of the gate speed during normal
movement (not soft start/stop) on scale of 20% to 100%
(20% being the lowest setting). It is recommended to set to
default of 100.
• LOW: Sets limit of the gate speed while in LEARNING mode
and when moving in SLOW, on scale of 20% to 100% (20%
being the lowest setting). Recommended not to be set lower
than 50. Default setting depends upon learning parameters
• SLOWDOWN: Set gate speed when approaching the open
or close limits on scale of 20% to 100% (20% being the lowest
setting). Recommended not to set lower than 50% for slide
gates. The lower this setting the less power the operator
will have when approaching the limit. Setting too low could
cause a stall condition prior to open/close limit.
• ACCELERATION: Adjusts the rate of acceleration/
deceleration when the motor starts and stops moving:
» MAX: Sets the limit of gate acceleration and
when reversing the gate after an obstacle has been
detected by the UL/Edge or current sense feature (Force).
Settings from 3 to 10, with 10 being the highest rate of
gate acceleration.
» STANDARD:
Sets the limit of the gate acceleration and
deceleration in normal operation. Settings from 1 to 10,
with 10 being the highest rate of gate acceleration. * *TO
PREVENT DAMAGE TO THE GATE OR THE CONTROLLER
USE LOWER ACCELERATION SETTINGS FOR HEAVIER
GATES.
» ESC: Exit the SPEED / ACCELERATION menus.
deceleration
45