Fitting And Installation; Installation; Pre-Requirements; Identification Of The Cable - Assa Abloy ePED 1386-00 Installation And Fitting Instructions

I
I
Tab. 4 :
Colour coding for
wiring

Fitting and installation

Fitting and installation

Installation

Pre-requirements

Plan and install the wiring before the ePED
mounted (manual D0102100 ePED
Note!
Protection rating IP30 must be achieved: Switch boxes (Fig. 28) which achieve a
minimum protection rating of IP30 must be used for the installation.
Attention!
Limitation of function with incorrect operating voltage at the components. A
mains adapter in accordance with DIN EN 60950-1 SELV must be used. Separate mains
adapters must be connected for the supply of devices with power consumption higher
than 100 VA. The appropriate mains adapter, the cable lengths, and cable cross sections
must be chosen according to the local circumstances. Check and ensure that the oper-
ating voltage at the connection points is suitable for the components.

Identification of the cable

Note!
Choose uniform identification for avoidance of errors: In order to avoid errors
and for a clearer overview during installation and maintenance, ASSA ABLOY Sicher-
heitstechnik recommends uniform identification and colour coding of the cable
cores Tab. 4.
Function
CAN_H
CAN_L
Hi-O
V +
B
GND
® Hi-O Technology™ bus).
Screw
terminal
Hi-O
1 wh
2 br
3 gn
4 ye
® 1386-00 door terminal has been
Colours
CAN bus
J-Y(ST)Y 4x2
wh/br
br
gn
wh/gn
Typical
9
9
9
EN 39