Assa Abloy Corbin Russwin ED5800 Series Installation Instructions Manual

Installation Instructions
Shim (2) Supplied
Strike Plate
(3) 10-24 x 3/4" PFHMS
Strike
(6) 10-24 x 1/2" PFHMS
Top Latch
Top Tube
8' (2.44m) Opening
7'6" (2.29m) Opening
7'2" (2.18m) Opening
7' (2.13m) Opening
Top Rod
(2) Arm & Bracket Assembly
(2) Yoke Pin
(5) Cotter Pin
(2) Set Screw
#8-32 UNC
(2) 1/4-20 X 3/4" PRHMS
(Special Head)
Bottom Rod Assembly
Deadbolt
Bottom Bolt Case
(6) 10-24 x 1/2" PFHMS
Strike
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2012, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
ED5800 (A) Series
Hole Plug
(Fire Devices)
(2) E-Rings
(2) #8-32 X 2" PHPMS Temporary Screws
Cover
2) 8-32 x 5/16" PUFHMS
Concealed Vertical Rod
Important:
For use with metal doors only.
Device is packed ready for any compatible trim.
End Clamp
(2) 1/4-20 X 3/4" PRHMS
Dogging
Key
Dogging:
Feature to hold bolts retracted and touchpad
depressed for push-pull door operation.
Note: Dogging is not a feature of fire labeled
devices.
To Dog Device
1. Insert dogging key.
2. Hold touchbar depressed.
3. Turn key 1/4 turn clockwise.
WARNING
This product can expose you to lead
which is known to the state of California
to cause cancer and birth defects or other
reproductive harm. For more information go
to www.P65warnings.ca.gov.
Exit Device
(3) 8-32 x 5/16"
PUFHMS
End Cap
FM171 01/19