Resetting To Normal Operation; Combination Inputs - Assa Abloy ePED 1386-00 Installation And Fitting Instructions

!
Functions

Resetting to normal operation

The system must be reset for normal operation after an Emergency unlock or a
safety-related fault.
Resetting to normal operation is possible after 60 seconds if no Emergency re-
lease commands are present and/or all causes of faults have been eliminated.
A function test is performed automatically depending on the cause of fault. If the
fault has been corrected and functionality has been re-established, the escape
route securing system will be locked in order to test the Hi-O Technology™
components.
If release commands are to be executed, the systems will be unlocked again;
otherwise the Locked status remains in effect.
If the function test shows that a fault remains, the cause can be determined in
detail with the external display module 1386D00-DISP.
Warning!
Danger arising from tampering or improperly performed repairs: If the ePED
terminal 1386-00 or parts of the device cannot resume normal operation after a
fault or alarm message, or if there is evidence of damage, the device may only be
repaired by a qualified person. Please contact the customer service of the installa-
tion company or the support department of ASSA ABLOY Sicherheitstechnik GmbH
("Warranty," page 59).

Combination inputs

Additional functions can be executed with combination inputs. Combinations
inputs are activated via electrical contacts.
Potential-free contact of the on-site electronic access control system:
Locked status
· Temporary release start
· Temporary contact <= 2 seconds
Locked or Temporary release status
· Permanent unlocking start
· Temporary contact > 5 seconds
Permanently unlocked or Temporary release status
· Lock = Temporary contact
Emergency unlock or Fault status
· Resetting to normal operation = Temporary contact
®
EN 19