Date/Time (Function 58) - Siemens FIDAMAT 6 Operating Instructions Manual

Functions
8.5 Parameters
When the flame is burning, "Flame burns" appears on the display. If it goes out, this
message disappears.
8.5.10

Date/time (function 58)

Figure 8-35
With this function, you can set the date and time.
The cursor is already located at the first place of the date display. Enter the new settings in
the order: day, month, year. By pressing [ENTER], jump to the next input field. Set the time
in the same way (hours, minutes).
The system clock of the device is not buffered against mains failures (not a real-time clock).
Note
When the device is switched off, the clock stops and is not updated.
The settings are especially important for troubleshooting. Errors which are always stored in
the logbook (function 60) can be allocated more easily with the help of the date and time.
Press the third softkey
bottom edge of the display.
See also
Logbook (function 3) (Page 78)
Logbook settings (function 60) (Page 103)
102
Setting the date/time
"Set clock"
in order to accept the set data. These then appear at the
Operating Instructions, 01/2019, A5E00222135-04
FIDAMAT 6