On/Off Functions (Function 52) - Siemens FIDAMAT 6 Operating Instructions Manual

Functions
8.5 Parameters
See also
Logbook (function 3) (Page 78)
On/off functions (function 52) (Page 96)
Relay outputs (function 71) (Page 107)
8.5.4

On/off functions (function 52)

Figure 8-27
Note
Device-specific on/off functions can only be called using the first component ("THC").
With this function, you can easily switch other functions on and off, such as the ones listed in
the above function screen.
Thanks to this simplified operation, these functions do not have the longer paths through
various menus. For better orientation, the function numbers have also been specified.
Activated functions are marked by "■", deactivated ones by "□". Using the fifth softkey
("...continue"), jump to the next function screen with further functions.
Function 52 is used to switch the following functions on and off:
Table 8- 2
Designation
Total range calibration
Automatic measuring range switchover
Limit alarm on/off 1
Limit alarm on/off 2
Limit alarm on/off 3
Limit alarm on/off 4
96
On/off configuration
Functions switched on/off by function 52
Function Remarks
23
40
51
51
51
51
Operating Instructions, 01/2019, A5E00222135-04
FIDAMAT 6