Honeywell Enhanced Micro TDC 3000 User Manual page 93

THIS STATION:
OTHER STATION:
* MAY BE VIEW.
To call up the display at a US running the Operator Personality, with the System Status
display on the screen, press HELP. This display appears with the OPER* target, but
without the SUPV and ENGR targets. You can select OPER* to change to the operator
keyswitch level.
To change to supervisor or engineer keyswitch level, select the TOUCH HERE TO ENTER
PASSWORD target, key in the password, and press ENTER. If you use an Engineer's
Keyboard, you must use capital letters. If you are in the Universal Personality and want to
go from operator keylock level to engineer keylock level, press PF1 on the Engineer's
Keyboard.
SUPV or SUPV and ENGR targets appear. Select the desired access level. The "THIS
STATION IS:" line changes to indicate the new keyswitch level.
The prebuilt passwords in systems shipped from the factory are TDC3000 SUPV and
TDC3000 ENGR (be sure to key in the space). You can call up the display as schematic
KEYLOCK.
The line that reads, "*MAY BE VIEW. CHECK ACCESS-CHG TARGET ON CONS-STATS
DISPLAY," reminds users that in Network Configuration, under System Wide Values, the
Default Access Level for this US may have been configured as VIEW (no database changes
allowed), rather than OPER, so selecting OPER results in the VIEW level. To verify the
actual keyswitch level for this US, call up the Console Status display and check under the
ACCESS heading.
Enhanced Micro TDC 3000 User's Manual
MASTER KEY DISPLAY
SELECT HERE TO ENTER
PASSWORD
THIS STATION IS:
OPER*
SUPV
OPER*
SUPV
CHECK ACCESS—CHG TARGET ON CONS-STATS DISPLAY
5-11
24 Feb 92 16:12:04
ENGR
ENGR
ENGR
5.3.3
1
11232
9/95