Honeywell Enhanced Micro TDC 3000 User Manual page 106

27
Figure 5-4 — Location and Function of Rear Controls for IDEK #8221
22. AC INPUT CONNECTOR
- Connect to the AC outlet with the supplied AC power cord.
Note: - Make sure the POWER SWITCH is turned OFF before connecting the
power cord.
23. 15PIN D-SUBSIGNAL INPUT CONNECTOR
- Allows equipment having analog RGB output to be connected.
24. BNC SIGNAL INPUT CONNECTORS
- Allows equipment having analog RGB output to be connected.
25. BNC INPUT VOLTAGE SWITCH (.07V/1.0V)
- Used to select the appropriate BNC video input voltage for your equipment.
- Set to 0.7V for 0.74 volt peak to peak or 1.0V for 1.0 volt peak to peak.
BNC IMPEDANCE SELECT SWITCHES (VIDEO: ∞/75Ω,
26.
SYNC: 4.7KΩ/1KΩ)
- Select 75Ω for the line impedance.
- If the monitor is used in a loop-through operation, set these switches to the left
(∞ for video, 4.7KΩ for sync). For single unit operation, or when the monitor
is the last unit in a loop-through string, set the switches to the right (75Ω for
video, 1KΩ for sync). The switches of the unused BNC SIGNAL INPUT
CONNECTORS should also be set to the right.
27. TILT-SWIVEL STAND
- Allows the screen angle to be adjusted by 90 degrees horizontally, 15 degrees
up and 5 degrees down.
Enhanced Micro TDC 3000 User's Manual
26
22
∞ ∞ ∞
75 75
R G/SYNC B
AC Line
24
5-24
25
1.0V
75 4.7K 1K 4.7K 1K
0.7V
BNC INPUT
VOLTAGE
H/HV V
5.4.2
23
RGB ANALOG
INPUT
52550
9/95