Honeywell Enhanced Micro TDC 3000 User Manual page 102

5. BRIGHTNESS CONTROL BUTTONS
- Press to adjust the picture brightness.
- When you press the BRIGHTNESS CONTROL BUTTONS at the
same time for over three seconds, you will hear a beep and the
adjusted brightness will be canceled and set back to the factory setting
"center."
6. CONTRAST CONTROL BUTTONS
- Press to adjust the picture contrast.
- You will hear short beeps when the contrast reaches its maximum
setting.
7. TONE CONTROL BUTTONS (RED/BLUE)
- Use to adjust the white tone as you prefer, other than WB1/WB2 selectable by the
RED
WHITE SELECT BUTTON.
- When the + button is kept pressed, the color tone becomes vivid
gradually. When the - button is kept pressed, it fades gradually.
- The user adjusted tone is automatically stored. It is recalled and
BLUE
readjustable by pressing either one of the TONE CONTROL
BUTTONS once when using WB1/WB2.
- You will hear a beep and the user adjusted tone will be canceled and
set back to the factory setting "WB1" when you press the WHITE
SELECT BUTTON for over three seconds.
8. WHITE SELECT BUTTON (WB1/WB2)
- Use to select white balance either WB1 (9300˚K: bluish white) or WB2 (6500˚K:
1 2
reddish white).
- Pressing the button alternates between the white balances and the
indicator will be illuminated in either case.
WB
- Neither indicator blinks when the user adjusted/adjustable tone is
selected by pressing either one of the TONE CONTROL BUTTONS
once.
9. SIGNAL SELECT BUTTON (BNC/D-SUB)
- Use to select the input signal either from the BNC CONNECTORS or from the 15PIN
BNC D-SUB
D-SUB CONNECTOR.
- Pressing the button alternates between the input connectors and the
indicator will be illuminated in either case.
SIGNAL
Enhanced Micro TDC 3000 User's Manual 5-20
5.4.2
9/95