Honeywell Enhanced Micro TDC 3000 User Manual page 111

5.4.3.2 Operator Controls
The monitor usually operates in the Operation mode, and the picture is aligned according to
the data in the internal memories that correspond to the video signal input.
Press the SELECT button, the monitor enters in the Adjustment mode, and the picture
becomes adjustable.
• MAIN SWITCH switch (see Figure 5-4)
- Turn on the power for the monitor by pressing the MAIN POWER switch to the
"ON" position (the "1" side of the switch) on the rear panel.
- To turn off the main power, press the MAIN POWER switch to the "OFF"
position (the "0" side of the switch).
IMPORTANT—If you do not use the monitor for a long time, please turn off MAIN
POWER switch on rear panel.
• FRONT POWER switch
- If you want the monitor in Off mode by FRONT POWER switch, while MAIN
POWER switch in on, press this switch button. The POWER indicator will
turn to green.
- To change the monitor from Off mode to Operation mode, press the FRONT
POWER switch button or turn on/off the MAIN POWER switch.
NOTE: If the monitor is in Stand-by mode or Suspend mode, you can not operate the
monitor until the input signal status is returned to On Mode 1. Please see next
item.
• POWER indicator
This monitor has power save mode, and POWER indicator lights as follows:
Power Save
Mode
On
Stand-by
Suspend
Off (H.V. loss)
Off (FRONT POWER
switch is Off.)
Off (MAIN POWER
switch is Off.)
Enhanced Micro TDC 3000 User's Manual
Power Horizontal
Indicator Sync Signal
Green In
Orange Out
Orange In
Orange Out
Orange All
conditions
Off Out
5-29
Input Signal Status
Vertical Video
Sync Signal Signal
In
In Out
Out Out
Out Out
All All
conditions conditions
Out Out
5.4.3
In
9/95