Table of Contents
Advertisement
5.4.2 IDEK Model MF-8221
Subsection 5.4.2 describes the operational controls of the IDEK 21-inch Vision Master
Monitor (newer monitor Model MF-8221). The numbered description of each of the
digital, pushbutton screen controls make reference to the identification number shown in
Figure 5-3.
3
4
Control Buttons
on the Sliding Tray
Figure 5-3 — Location and Function of Front Controls for IDEK #8221
1.
POWER SWITCH (ON/OFF)
-
Use to turn the power ON or OFF.
-
Press the switch to turn ON and press it again to turn OFF.
2.
POWER/STANDBY INDICATOR
-
Indicates power-ON/OFF or stand-by state.
-
When the power is ON, green light comes on, and it goes off when the power
is OFF. When the AUTO POWER-OFF SENSOR is activated and switches to
the stand-by state, the green light turns red.
3.
AUTO POWER-OFF SENSOR
-
To save energy, it detects the presence of an operator and powers down to the
standby state automatically when no one is in front of the monitor for over an
hour.
-
To turn the power back on in the standby state, the following two ways are
available:
One is to press the AUTO POWER-OFF setup swtich.
The other is to press the POWER SWITCH and make sure the red light goes
off. Then press it again and green light will come on.
Note: -
Do not place anything in front of the sensor. It doesn't operate properly
when it is dirty or covered.
4.
AUTO CONTRAST SENSOR
-
To avoid eye strain and reduce energy, it adjusts the screen contrast
automatically as the ambient light of the room changes.
Note: -
Do not place anything in front of the sensor. It doesn't operate properly
when it is dirty or covered.
Enhanced Micro TDC 3000 User's Manual
13
14
15
1
2
RED
5
6
5-19
16
17
18
19
1
2
BNC
D-SUB
BLUE
WB SIGNAL AUTO
AUTO
SIZE
CONT
7
8
9
10 11 12
5.4.2
20 21
LOCK
DG
AUTO
POWER
52549
9/95
Hide quick links:
Advertisement
Table of Contents
