Spare Parts - Honeywell Enhanced Micro TDC 3000 User Manual

• Note that the front (large) boards can be accessed through the front of each tower
by removing the front cover. Remove it by grasping the edges of the panel near the
bottom and pulling straight out. With the front cover removed, inspect the
confidence indicators on each node's processor (see Figure 3-1). Check the power
supply and fan confidence indicators. To replace the cover, slip it under the top
front edge and snap it into the two bottom spring catches.
• The small I/O or paddle boards (see Figure 2-3) are accessed from the rear through
a center panel held in place with four M5 screws.
• If the history module is the only application not working, check the Winchester
power supply in the bottom of tower #2—the circuit breaker on the supply may be
off. Access this breaker through the rear center-section of tower #2.
To isolate a failed board, power supply, fan assembly, or other Optimum Replaceable Unit
(ORU), follow the service procedures provided in the 8-Node Multinode Module Service
manual in the Implementation/8-Node Enhanced Micro TDC 3000 binder.
Service Information for the cartridge drives and the ASPI-41 printer is provided in
Universal Station Service in the LCN Service - 1 binder.

6.5 SPARE PARTS

Table 6-4 — Parts List
PART NUMBER
51196739-100
* 51195652-100
51195904-006
51190921-100
51190921-200
* 51196075-100
* 51196363-100
* 51197007-100
51197019-100
* 51197005-100
51195904-XXX
* 51302287-100
* 51302297-100
* 51108385-508A
* 51195904-106
51303654-092
51303655-092
* 51201201-600
* 51108305-100
* ORU Level Replacement Item
(1) Complete 21" Touchscreen Asm. available by ordering: MX-MTTS11-100 (not including monitor)
Enhanced Micro TDC 3000 User's Manual
Document Reference
20" CRT
20" CRT I/C CABLE
20" CRT POWER CORD
20" CRT POWER CORD
21" CRT
21" CRT
TOUCHSCREEN FOR 21" CRT
TOUCHSCREEN FOR 21" CRT
CONTROL BOX
CABLE SET
MICRO CABLE
UTDC CABLE
M4X8 SCREWS-21" TCH SCRN Cable connector Screws at M/F (1)
21" CRT CABLE
AC 125 V POWER CORD
AC 250 V POWER CORD
AIR FILTER
ASPI 41 PRINTER
6-10
DESCRIPTION
Micro TDC Configurations
Color Monitor
Cable from Transition Panel to CRT
120 V Power Cord for CRT
240 V Power Cord for CRT
21-Inch FST Desk-Top Color Monitor
21-Inch Multi-Sync CRT Color Monitor
T/S for 21" FST Desk-Top Color Mon. (1)
T/S for 21" Multi-Sync Color Monitor (1)
Control Box for 21" Touchscreen (1)
Video Copier to EPDG Cable
Micro cable for 21" Touchscreen (1)
UTDC cable for 21" Touchscreen (1)
21-Inch RT Data Cable
AC Cable for Winchester Power Supply
AC Cable for Winchester Power Supply
Air Filter in the top of each tower
Printer
6.5
(Continued)
9/95