Attach Enb To Wall; Recommendations For Installing; Figure 3-20: Completed Pole Mount; Figure 3-21: Wall Mount - Baicells Nova-233 G2 Installation Installation

Figure 3-20: Completed Pole Mount

3.7.2 Attach eNB to Wall

When mounting the eNB on a wall, the wall must bear at least four times the weight of the
eNB. Follow the steps below for wall installations.
1. Take apart the assembled installation bracket kit. Fit the bracket on the wall, and mark
the drilling locations (Figure 3-21). Ensure that the arrow on the mounting bracket is
pointing upward.

Figure 3-21: Wall Mount

2. Drill two 0.4-inch (10-mm) diameter and 2.8-inch (70-mm) depth holes in the
wall using the marked locations.
3. Check the up/down direction of the installation rack, and then fix the eNB to the
wall using M8*80 expansion screws.
4. Tighten the screws on the top of eNB bracket using a cross screwdriver. The wall
installation is complete.
5. Proceed to section 3.7.3.

3.7.3 Recommendations for Installing

In general, it is best to keep the RF cable length between the eNB and antenna as short as
possible to minimize signal attenuation. Typically, the eNB will be located within a few feet
from the antenna.
This section provides guidance on GPS placement considerations and explains how to install
the eNB and an omni or directional antenna on an outdoor tower, building, or other structure.
26