Figure 3-17: Pole Bracket Part 1; Figure 3-18: Pole Bracket Part 2; Figure 3-19: Connect Mounting Bracket To Pole Bracket - Baicells Nova-233 G2 Installation Installation

Figure 3-17: Pole Bracket Part 1

Noting how high up the pole the eNB will rest, fit the threaded rod of the assembled
2.
bracket to the pole, pass the omega clamps through the threaded rods, and fasten the
four flat gaskets, four spring gaskets, and four nuts or screws. Refer to Figure 3-18. The
arrow on the bracket should point upward.

Figure 3-18: Pole Bracket Part 2

3. Lifting the eNB, hook the two pins that are part of the bracket on the back of the eNB into
the pole bracket, pushing the eNB down until it locks securely to the pole. Refer to Figure
3-19.

Figure 3-19: Connect Mounting Bracket to Pole Bracket

4. Tighten the screws on the top of the eNB mounting bracket using a cross screwdriver.
The completed pole attachment is shown in Figure 3-20. Proceed to
5.
25
section 3.7.3.