Baicells Nova-233 G2 Installation Installation page 2

About This Document
This document is intended for personnel who will be installing the Baicells Nova-233
Generation 2 (G2) Outdoor 2x1W eNodeB which is based on Long-term Evolution (LTE) Time
Division Duplexing (TDD). The information includes preparation of installation tools and
materials and procedures for properly installing the eNB, initially configuring it, and verifying
its operational status. Please be advised that only personnel with the appropriate electrical
skills and experience should install this device.
Copyright Notice
Baicells Technologies, Inc., copyrights the information in this document. No part of this
document may be reproduced in any form or means without the prior written consent of
Baicells Technologies, Inc.
Disclaimer
The information in this document is subject to change at any time without notice. For more
information, please consult with a Baicells technical engineer or the support team. Refer to
the "Contact Us" section below.
Disposal of Electronic and Electrical Waste
Pursuant to the WEEE EU Directive, electronic and electrical waste must not be
disposed of with unsorted waste. Please contact your local recycling authority for
disposal of this product.
Revision Record
Date Version
17-Dec-2019 V1.13
6-Dec-2019 V1.12
29-Nov-2018 V1.11
Description
Sync IGs
Updated to RTS 3.4.8,
new PLMN, general info
Added information on
setting WAN Connect Type
before installing eNB
2
SMEs/Contributors
Sonny May
Nitisha Potti
Author/Editor
Sharon Redfoot
Sharon Redfoot