Attach Power Connector <Checking Fig/Tbl #S; Connect Ground Cable; Figure 3-5: Live And Neutral Wire Connections - Baicells Nova-233 G2 Installation Installation

3.3.6 Attach Power Connector
The two ends of the power adaptor are bare terminal ends, since the distance between the
installation site and the power supply device will vary. You will need to make the power cable
specific to this site, and attach the power plug and power terminal on the two ends of the
power adaptor. It is recommended that the power cord length be kept below 330 feet (100
meters).
Strip about ½ inch (12 mm) of the insulating layer with a wire stripper. Follow the steps below
to attach the plug and connector, and to complete the wiring to the eNB.
1. Assemble the power plug (input).
The power plug will be installed on the end of the input direction, as indicated on the
power plug. Connect the live wire, neutral wire, and ground wire to the corresponding
terminals separately, and tighten the screws.
2. Assemble the power terminal (output).
The power terminal will be installed on the end of the output direction. Refer to Figure 3-5 to
connect the live wire and neutral wire.

Figure 3-5: Live and Neutral Wire Connections

3. Connect the power cable to the PWR interface in the eNB's wiring cavity.
4. Lay the power cable along the duct slot, stretching it from the PWR interface out the
wiring cavity.
5. Plug the power plug end into the power source, i.e., electrical outlet.
If the outlet is indoors, place the power adaptor indoors.

If the outlet is outdoors, place the power adaptor in a waterproof box.

6. After the cable connection in the wiring cavity is complete, close the cover and use an M4
cross screwdriver to tighten the screws.

3.3.7 Connect Ground Cable

Refer back to section 2.5 for general grounding and lightning protection guidance.
You will need to make the grounding cable specific to the cell site. Looking at Figure 3-6, follow
the steps for connecting the grounding cable to the eNB.
17