Figure 3-10: Wan/Lan; Figure 3-11: Dhcp - Baicells Nova-233 G2 Installation Installation

b. LAN - The LAN address is the same one used to access the eNB GUI:
192.168.150.1. The subnet mask is 255.255.255.0.

Figure 3-10: WAN/LAN

4. Optional: If a local DHCP server will be used, go to the Network > DHCP menu and
click on the check box next to LAN DHCP Server Enabled (Figure 3-11). Enter the start
(lowest) leased IP address and the end (highest) leased IP address in the range. The
lease time field is used to indicate how long a leased IP address remains active
before it expires. The range of time may be up to 9,999 hours; the default is 12
hours.

Figure 3-11: DHCP

5. Verify the core network connection between the eNB and the Mobility Management
Entity (MME) in the Baicells CloudCore. Go to Network > MME/IPSec Binding (Figure
3-12). Do not change the IPSec Setting fields. They should be left with their default
values. In the IPSec Tunnel List, verify there are 2 tunnels enabled. The IPSec Binding
should show the 2 CloudCore MME IP addresses, 10.3.0.9 and 10.5.0.9.
Point-to-Point Protocol Over Ethernet (PPPoE) – not
•
recommended. If PPPoE is selected, you will be prompted to
enter the user name and password. The range of each is 1 to 100
digits. You can also enter an access controller name and service
name.
• Static IP – IPv4 address, netmask, and gateway or IP address of
the Domain Name Server (DNS), where multiple addresses are
allowed.
20