Table of Contents
Advertisement
Step 1.
Plug one end of the feeding pipe (#1) into the push-fitting located at the
top of the hot end (identified by the blue plastic ring) and the other end
into that of the extruder (#56A/B).
Note:
Before connecting the feeding pipe, you need to match the extruder and
the hot end.
extruder is referred to as "extruder 2" and the right one is "extruder 1".
www.geeetech.com
ShenZhen GETECH CO.,LTD
GEEETECH
From the viewpoint of back ("Z" tower) the left side
Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 – 858
Page
65
Advertisement
Table of Contents
Need help?
Do you have a question about the Delta Rostock mini G2 pro and is the answer not in the manual?