Adjusting The Lift Arms - Toro 30809 Operator's Manual

2
Figure 6
1. Hood latch bracket
3. While aligning the mounting holes, position the CE
lock bracket and the hood latch bracket onto the hood.
The lock bracket must be against the hood (Figure 7).
Do not remove bolt and nut assembly from the lock
bracket arm.
1
Figure 7
1. CE lock bracket
4. Align the washers with the holes on the inside of the
hood.
5. Rivet the brackets and the washers to the hood (Figure
7).
6. Hook the latch onto the hood latch bracket (Figure 8).
1
G012628
2. Rivets
2
G012629
2. Bolt and nut assembly
1
1. Hood latch
7. Screw the bolt into the other arm of hood lock bracket
to lock the latch in position (Figure 9). Tighten bolt
securely but do not tighten nut.
3
2
1. Bolt
2. Nut
4

Adjusting the Lift Arms

No Parts Required
Procedure
1. Start the engine, raise the cutting units, and check to
ensure that the clearance between each lift arm and the
floor plate bracket is 0.18 to 0.32 inches (5 to 8 mm)
(Figure 10).
15
G012630
Figure 8
1
G012631
Figure 9
3. Arm of hood lock bracket