Installing The Ce Decal; Installing The Hood Latch - Toro Groundsmaster 3500-D Operator's Manual

WARNING
Incorrect battery cable routing could
damage the tractor and cables, causing
sparks. Sparks can cause the battery
gases to explode, resulting in personal
injury.
• Always disconnect the negative
(black) battery cable before
disconnecting the positive (red)
cable.
• Always connect the positive (red)
battery cable before connecting the
negative (black) cable.
1. Positive (+) battery cable
Important:
If you ever remove the battery,
install that the battery-clamp bolts with the
bolt heads positioned on the bottom side
and the nuts on the top side. If the clamp
bolts are reversed, they may interfere with
the hydraulic tubes when shifting the cutting
units.
9. Coat both battery connections with Grafo 112X
(skin over) grease (Toro Part No. 505-47),
petroleum jelly, or light grease to prevent
corrosion.
10. Slide the rubber boot over the positive terminal
to prevent a possible short from occurring.
11. Install the battery cover.
Figure 4
2. Negative (–) battery cable
2

Installing the CE Decal

Parts needed for this procedure:
1 Decal (121-3598)
Procedure
If this machine will be used for CE, affix the
CE-warning decal over the corresponding English
warning decal.
3

Installing the Hood Latch

CE Only
Parts needed for this procedure:
g031568
1 Lock bracket
2 Rivet
1 Washer
1 Screw (1/4 x 2 inches)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket.
2. Remove the 2 rivets securing the hood-latch
bracket to the hood
12
(Figure 5).